Ne, nes veiksmas islieka po tuo paciu cciss

On 04/08/10 20:02, arulis wrote:
> Ok, yra kitas arrayus atskiras p212 - verta statyti del to?
> 
> "rabarbaras" <rabarbaras@zebra.lt> wrote in message 
> news:hpedf8$u3f$1@trimpas.omnitel.net...
>> Kai prasides problemos su strymeriu (ar juostom), ir jei an to paties
>> kontrolerio sisteminis diskas - bus daug vertingos patirties.
>>
>> On 04/02/10 18:09, arulis wrote:
>>> nu va aciu labai, jau kazka dmesgas atrado po sio skriptuko:
>>>  for x in /proc/driver/cciss/cciss[0-9]*
>>>         do
>>>                 echo "engage scsi" > $x
>>>         done
>>>
>>>
>>> scsi2 : cciss
>>>   Vendor: HP        Model: DAT160            Rev: WS92
>>>   Type:   Sequential-Access                  ANSI SCSI revision: 03
>>> st 2:0:0:0: Attached scsi tape st0
>>> st0: try direct i/o: yes (alignment 512 B)
>>> st 2:0:0:0: Attached scsi generic sg1 type 1
>>> st0: Block limits 1 - 16777215 bytes.
>>>
>>> Kokie dar niuansai gali buti, jei sakai kad bus nefaina
>>>
>>>
>>>
>>> "rabarbaras" <rabarbaras@zebra.lt> wrote in message
>>> news:hp3uq3$8jl$1@trimpas.omnitel.net...
>>>> su cciss bus nefaina. Paskaityk kernelio
>>>> Documentation/blockdev/cciss.txt
>>>>
>>>> On 04/01/10 22:41, arulis wrote:
>>>>> Sveiki, uzveskit ant kelio:
>>>>> prisireike pakurti subj. po centos5 x64 . nesusidures anksciau su
>>>>> juostom,
>>>>> tai ir uzsiknisau.
>>>>>
>>>>> hardwaras  proliant su P410i smartarray.
>>>>>
>>>>> BIOSE arrajaus utilitke rodo SAS RAID-1 masyveli ir Tape irengini.
>>>>> po linuxu niekas nieko neranda - nei HP tape diagnostic toolsas.
>>>>>  nezinau net kur ieskoti sio irenginio tarp /dev/*
>>>>> /dev/cciss/p0d0 /dev/cciss/p0d0p* mato tik diskus . dmesg nieko neradau
>>>>> kad
>>>>> detektuotu.
>>>>> modprobe st - niekas nepasikeite.
>>>>> dar bandziau su atskira HP p212 smart array ploste - biose mato, po
>>>>> linuxu
>>>>> atsiranda tik toks irenginys
>>>>> /dev/cciss/p1d0
>>>>>
>>>>>
>>>>>
>>>>>
>>>
>>>
> 
>