Tema: Re: patarkit del kompo zaidimams... 65KB
Autorius: MRT
Data: 2012-02-29 15:54:29
> ant 1600 paleides, nes defaultu rodos 1333 norejo, nieko daugiau neturbinau nes ir taip veikia, vakar kaip tik Skyrima ant ultra 
> high paleidau, nepajutau didelio skirtumo, gal tik kiek fps akyse maziau patapo, ar peveluotai milisekundem pele juda, bet 
> lyginant kas buvo anksciau... :)

Va dabar bent supranti, kad tie ultra turbosai ne tik brangiau, bet dar ir default'a eiliniu ram'u turi..

> Overclocked memory modules often must be manually configured in your BIOS in order to achieve the overclocked settings.  A memory 
> module which supports XMP (eXtreme Memory Profile) allows you to simply enable XMP mode in the BIOS which would then automatically 
> configure your memory settings for the correct voltage, speed and latency values.

http://www.corsair.com/memory-by-product-family/vengeance/vengeance-8gb-dual-channel-ddr3-memory-kit-cmz8gx3m2a1600c8.html

Tested Voltage 1.5
SPD Voltage 1.5
Speed Rating PC3-12800 (1600MHz)
SPD Speed: 1333Mhz
Tested Speed: 1600Mhz
Tested Latency: 8-8-8-24
SPD Latency: 9-9-9-24

***

123 Lt - 2x4GB 1333Mhz CL9 .. firma Kingsnon, vadinas OK:
http://www.skytech.lt/8gb-1333mhz-ddr3-nonecc-cl9-dimm-kit-p-31642.html

135 Lt - Kingston 2x4GB 1600MHz DDR3 Non-ECC CL9 DIMM XMP HyperX Blu (Red)
http://www.skytech.lt/kingston-2x4gb-1600mhz-ddr3-nonecc-cl9-dimm-xmp-hyperx-blu-red-p-108974.html

vos +12 Lt.. gal ir geris.. gerai atrodo.. greitesni.. bet:
http://www.kingston.com/datasheets/KHX1600C9D3B1RK2_8GX.pdf

DESCRIPTION
Kingston's KHX1600C9D3B1RK2/8GX is a kit of two
512M x 64-bit (4GB) DDR3-1600 CL9 SDRAM (Synchronous DRAM),
2Rx8 memory modules, based on sixteen 256M x 8-bit  FBGA
components per module. Each module kit supports Intel® XMP
(Extreme Memory Profiles). Total kit capacity is 8GB. Each
module kit has been tested to run at DDR3-1600 at a low
latency timing of 9-9-9 at 1.65V. The SPDs are programmed to
JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V.
Each 240-pin DIMM uses gold contact fingers and requires
+1.5V. The JEDEC standard electrical and mechanical specifi-
cations are as follows:

**********

Akcentuoju:
SPDs are programmed to JEDEC standard
latency DDR3-1333 timing of 9-9-9 at 1.5V.