realiai HT dar sumazina FPS skaiciu, kuo isitikinau ir pats :) kas idomiausia i7-920 kai kur netgi lenkia i7-2600K :D http://www.hardocp.com/article/2011/01/03/intel_sandy_bridge_2600k_2500k_processors_review/4 toki senuka i3-540 as turiu :))) "Milordas" <no@spam.lt> parašė naujienų pranešime:jilbbv$c0p$1@trimpas.omnitel.net... > nu tai ple lygina w/ HT ir w/o HT kur teisybe :) > > "markoh" <m@mail.tk> wrote in message > news:jilb0n$bhh$1@trimpas.omnitel.net... >> sakai i3 blogai ? >> http://www.overclock.net/t/943540/i3-vs-i7-gaming-performance-updated >> >> >> "Milordas" <no@spam.lt> parašė naujienų >> pranešime:jilat1$bcn$1@trimpas.omnitel.net... >>> tai cia viskas suprantama kad defaultas yr, yra zaporozke ir mercedesas, >>> abu vaziuoja bet priklausomai kaip vaziuoja.. kaip ir notebukuose 5400 >>> rpm hdd defaultu pastoviai vietoj 7200, kaip ir procai i3, i5 ir i7 >>> >>> "MRT" <martynas@fastlink.lt> wrote in message >>> news:jilaml$b4m$1@trimpas.omnitel.net... >>>>> ant 1600 paleides, nes defaultu rodos 1333 norejo, nieko daugiau >>>>> neturbinau nes ir taip veikia, vakar kaip tik Skyrima ant ultra high >>>>> paleidau, nepajutau didelio skirtumo, gal tik kiek fps akyse maziau >>>>> patapo, ar peveluotai milisekundem pele juda, bet lyginant kas buvo >>>>> anksciau... :) >>>> >>>> Va dabar bent supranti, kad tie ultra turbosai ne tik brangiau, bet dar >>>> ir default'a eiliniu ram'u turi.. >>>> >>>>> Overclocked memory modules often must be manually configured in your >>>>> BIOS in order to achieve the overclocked settings. A memory module >>>>> which supports XMP (eXtreme Memory Profile) allows you to simply >>>>> enable XMP mode in the BIOS which would then automatically configure >>>>> your memory settings for the correct voltage, speed and latency >>>>> values. >>>> >>>> http://www.corsair.com/memory-by-product-family/vengeance/vengeance-8gb-dual-channel-ddr3-memory-kit-cmz8gx3m2a1600c8.html >>>> >>>> Tested Voltage 1.5 >>>> SPD Voltage 1.5 >>>> Speed Rating PC3-12800 (1600MHz) >>>> SPD Speed: 1333Mhz >>>> Tested Speed: 1600Mhz >>>> Tested Latency: 8-8-8-24 >>>> SPD Latency: 9-9-9-24 >>>> >>>> *** >>>> >>>> 123 Lt - 2x4GB 1333Mhz CL9 .. firma Kingsnon, vadinas OK: >>>> http://www.skytech.lt/8gb-1333mhz-ddr3-nonecc-cl9-dimm-kit-p-31642.html >>>> >>>> 135 Lt - Kingston 2x4GB 1600MHz DDR3 Non-ECC CL9 DIMM XMP HyperX Blu >>>> (Red) >>>> http://www.skytech.lt/kingston-2x4gb-1600mhz-ddr3-nonecc-cl9-dimm-xmp-hyperx-blu-red-p-108974.html >>>> >>>> vos +12 Lt.. gal ir geris.. gerai atrodo.. greitesni.. bet: >>>> http://www.kingston.com/datasheets/KHX1600C9D3B1RK2_8GX.pdf >>>> >>>> DESCRIPTION >>>> Kingston's KHX1600C9D3B1RK2/8GX is a kit of two >>>> 512M x 64-bit (4GB) DDR3-1600 CL9 SDRAM (Synchronous DRAM), >>>> 2Rx8 memory modules, based on sixteen 256M x 8-bit FBGA >>>> components per module. Each module kit supports Intel® XMP >>>> (Extreme Memory Profiles). Total kit capacity is 8GB. Each >>>> module kit has been tested to run at DDR3-1600 at a low >>>> latency timing of 9-9-9 at 1.65V. The SPDs are programmed to >>>> JEDEC standard latency DDR3-1333 timing of 9-9-9 at 1.5V. >>>> Each 240-pin DIMM uses gold contact fingers and requires >>>> +1.5V. The JEDEC standard electrical and mechanical specifi- >>>> cations are as follows: >>>> >>>> ********** >>>> >>>> Akcentuoju: >>>> SPDs are programmed to JEDEC standard >>>> latency DDR3-1333 timing of 9-9-9 at 1.5V. >>>> >>>> >>> >>> >> >> > >