Smart 0,8 cdi 2012 , retkarciais (kartą į porą dienų) dingsta trauka, neima 
apsuku , uzgesinus ir uzvedus vel, problema dingsta.
Vokieciu/anglu forumai sako kad tai tipinis smart cdi bugas, atsirades 2010 
m. kai buvo prideta PDF ir kitu navarotu, kad atitiktu EURO5.
Bijau vaziuoti i servisa, nes jauciu pasiulys pakeist visus daviklius, 
sklendes ir turbiną.
Ką patartų  vietiniai guru? Gal iš OBD matosi nuo kurio galo pradėti ieskoti 
slieku?

=================================================

Vehicle VIN: WME4513011K557694
Vehicle Manufacturer: Smart
Vehicle Calibration ID: Not present

Current Fault Log
------------------
P2173: Throttle Actuator Control System - High Airflow Detected
P0638: Throttle Actuator Control Range/Performance (Bank 1)
P2100: Throttle Actuator Control Motor Circuit/Open
P0228: Throttle/Pedal Position Sensor/Switch "C" Circuit High Input

Pending Fault Log
------------------
ECU reports no pending faults

Historic Fault Log
------------------
ECU reports no historic faults
Other discovered fault codes
(possibly pending, current or manufacturer specific)
----------------------------------------------------
U0103: Lost Communication with Gear Shift Module
P2797: Auxilary Transmission Fluid Pump Circuit Performance
P2617: Crankshaft Position Signal Output Circuit/Open
P2389: Unknown code - More information may be available on the web
P2552: Throttle/Fuel Inhibit Circuit
P2545: Torque Management Request Input Signal A Range/Performance
U0001: High Speed CAN Communication Bus

End of report.